Connection of the sauna heater to the mains

 

The sauna heater must be connected to the mains by a qualified electrician and in compliance with current regulations. Sauna heater is connected with a semi-permanent connection. Use A07BB-F or H07RN-F (60245 IEC 66) cables or a corresponding type. Other output cables (signal lamp, electric heating toggle) must also adhere to these recommendations. Do not use PVC insulated cable as a connection cable for the sauna heater.

A multipolar (e.g. 7-pole) cable is allowed, if the voltage is the same. In the absence of a separate control current fuse, the diameter of all cables must be the same, i.e. in accordance with the front fuse.

The connecting box on the sauna wall should be located within the minimum safety clearance specified for the sauna heater. The maximum height for the connection box is 500 mm from the floor

If the connection box is located at 500 mm distance from the heater, the maximum height is 1000 mm from the floor

Sauna heater insulation resistance: The sauna heater heating elements may absorb moisture from air, e.g. during storage. This may cause bleeder currents. The moisture will be gone after a few heating sessions. Do not connect the heater power supply through a ground fault interrupter.

Adhere to the effective electrical safety regulation when installing the sauna heater.

Cable & Fuse

Power kW Power supply cable
H07RN –F/
60245 IEC 66
mm²
400V 3N~
Fuse A

Power supply cable
H07RN –F/
60245 IEC 66
mm²
230V 3~

Fuse A Power supply cable
H07RN –F/
60245 IEC 66
mm²
230V 1 N~ / 2~
Fuse A
4.5 5 X 1.5 3 x 10 4 x 2.5 3 x 16 3 x 4.0 1 x 20
6.0 5 X 1.5 3 x 10 4 x 2.5 3 x 16 3 x 6.0 1 x 35
8.0 5 X 2.5 3 x 16 4 x 6.0 3 x 25 3 x 6.0 1 x 35
 
 
Cookies help us deliver our services. By continuing to browse this website, you agree to our use of cookies. OK